tank dividers ???

[hobbyorobsession]

does anyone make their own tank dividers from arcylic sheets? if so how do you go about cutting them, special router bit or table saw blade? i have both those tools but feel the rpm speed would melt the plastic as i cut it. does anyone have suggestions?

 

[luv_my_fishies]

it's easy if you know how.... PM me....

 

[luv_my_fishies]

no special router bit or table saw blade. What size are you needing?

 

[ShortyKiloGyrl]

Plastic canvas you can get works wonders if your fish are big enough. Super cheap and can be cut with just scissors. I use it in two of my tanks. If you make them a little too big so that they bow when you put them in the tank they stay pretty tight and don't have any problems. If you would like a picture let me know!

 

[shua]

your good on the table saw i cut 1" acrilic on mine

 

[shua]

i use PVC latus like you put around a porch

 

[Rick]

Cutting arcylic

You can cut arcylic the same way you cut glass. Lay it on a flat surface and score it with a sharp utilty knife, it will snap off were you scored it.

 

[hobbyorobsession]

Alright ill give it a go by snapping it. Thanks for the input everyone.

 

[shua]

good luck with that let me know when you need more aqrilc once it breaks

 

[naturalart]

I have a plastic blade for my skill saw, works great.